How to Install a Garage Door Opener

It is difficult to imagine owning a garage door without an automatic opener. Many of us, however, start every day with manually unlocking, opening, and relocking their garage doors by hand. Installing a garage door opener isn’t a difficult process, but you’ll need a second set of hands for a couple of the steps. If you’re a veteran DIY sort of person, you ought to be ready to handle installing your own garage door opener in only a couple of hours. Follow these steps, and opening and shutting your garage door are going to be as simple as pushing a button.

 

No matter what kit you’ve got chosen to put in, it should accompany equivalent essential parts. Start by aligning the T rails in order that they are laid call at the right sequence. Many of the highest brands of garage door TX openers accompany arrows on the T rails so lining them up so as should be a snap. You would like to then bolt them together in order that they become all one piece. You would like to then take the pulley and place it where it belongs in reference to the T rails and secure that in situ, as well.

 

You want to seek out the trolley unit and slide it onto the rails. Once the trolley unit is in situ, you’ll plow ahead and finish bolting the rails to the opener unit that your kit came with. This next step is often a touch complicated. You would like to use a screwdriver and slide it through one among the holes within the rails to carry the trolley within the same place. Begin to connect the belt or the chain to the trolley using the tools that came together with your kit. You’ll want to then wrap the chain or the belt round the pulley and again round the sprocket on the open unit. You’ll want to end this step by attaching the chain to the opposite side of the trolley unit.

 

The next part requires some measuring. Open your garage door to the very best possible point and measure it. Add on about 2 to three inches and mark it on your wall. Next, find the middle of your door and make another mark on the wall. This is often the spot where you would like the header bracket to be installed. You’ll get to use a 2 by 4 if there are not any wall studs in situ at that time.

 

Next, take the pulley end of your assembly and fasten it to the bracket above the door. Use a ladder to boost the whole assembly to close the tracks of your door. Now lookout to open the door and lift your garage door opener so it’s 2 inches above the open door. Confirm you employ shims here.

 

Use lag screws to connect the molding bracket to the ceiling of your garage. Attach your garage door opener unit to the bracket. At now, install the garage door controls and therefore the photoelectric cell censors. Finish by installing the brackets by the door. Before you recognize it, you’ll be completely finished and opening and shutting your garage door with ease.

Related Post

Leave a Reply

Your email address will not be published. Required fields are marked *